DAF LF,CF, XF NOTES TO THE FAULT CODES ABS / ASR-D. Fault Code Blink Code Location Cause Solution The first digit of the blink code identifies the system configuration: 1 6S/6M, 2 4S/4M, 4 6S/4M.
If you let me know the code i will look it up for you. (Flash Code 22) SPN 563 14 11 Inactive Advantage Series Neutral Coast Mode. 1-12-14 2-12-14 4-12-14 Left Rear Wheel Short circuit between steering axle ATC valve and battery.
1 flash, pause, then 2 further flashes.Ĭode 12 is the start code and code 11 is the end code anything in between is a fault code. Incidentally which type of bendix system is it:ġ: Integral system (with abs block on the padal assembly where the brake servo would be)Ģ: Addonex (has a brake servo and master cylinder with an additional pump unit with all the brake lins feeding into it)ġ: locate the grey 2 pin connector in the engine fuse housing next to the O/S upper engine mount.Ģ:Take a peice of wire long enough to reach into the car.Ĥ: Put the wire into the terminal of the 2 pin connector (only one has a terminal)ĥ:Sitting in the car, touch the wire to earth for a second.Ħ:The abs light will flash, count the flashes, this indicates the code. I would not change the ABS pump as in the 16 years i have worked on these it has never been the bendix pump that has failed. After you have read the code this will give you some idea of what is causing the problem and the area to investigate. You can read off the fault codes for the ABS system on this type yourself using a peice of wire.
